Installing Bronze pilot bushing

Print Thread

Installing Bronze pilot bushing #895912 01/04/11 10:00 AM 01/04/11 10:00 AM
Joined: Feb 2003 Posts: 4,503 NJ 4 440challenger OP master
440challenger OP master 4 Joined: Feb 2003 Posts: 4,503 NJ	IM installing a stock bronze pilot bushing in my steel crank 383. Its very tight going in..I was going to heat the crank a little bit and then freeze the bushing,but then i got to thinking. Are all factory steel crank 383's drilled to fit pilot bushings? And if they werent drilled would the hole even be close to the size that you think you would be able to drive a bushing into? Can I just remove some material from the outside of it?

Entire Thread
Subject	Posted By	Posted
Installing Bronze pilot bushing	440challenger	01/04/11 02:00 PM
Re: Installing Bronze pilot bushing	MLR426	01/04/11 02:57 PM
Re: Installing Bronze pilot bushing	Commando1	01/04/11 04:02 PM
Re: Installing Bronze pilot bushing	KillerBee	01/04/11 04:32 PM
Re: Installing Bronze pilot bushing	MO_PA	01/04/11 03:50 PM
Re: Installing Bronze pilot bushing	MLR426	01/04/11 05:43 PM
Re: Installing Bronze pilot bushing	feets	01/04/11 05:59 PM
Re: Installing Bronze pilot bushing	In_The_Pink	01/05/11 12:06 AM
Re: Installing Bronze pilot bushing	jrwoodjoe	01/05/11 02:33 AM
Re: Installing Bronze pilot bushing	440challenger	01/06/11 04:04 AM

Hop To