Hey all,

Been fighting this one for awhile. Got a 318-powered '88 W-150 converted to carb using an '86 360-4v intake and wiring from the same truck. Truck will fire up and run, though it sounds like one or two arent hitting, you can feel it run rough.

Carb is an Edelbrock 1406, I recently replaced a float because one had sunk. It acted up before this and after this.

Drop it into drive from a fast idle and it will stall. If you baby it and get it to start moving it bucks out real bad and makes kind of a pinging sound. Once its going its kind of okay. Stall low power and that dead miss.

Just yesterday it started stalling out at idle. It would slow down idling and then stall, not an immediate stall out. Choke it a bit and it keeps running.

Anyone got any ideas. Its not burning oil so I dont think its an intake leak. Would low fuel pressure cause issues like these?

I'm going to change plugs and wires tomorrow and see what that yields. Any other things I should check?