Thanks Ryan
Yes, NO Hole in the Threaded Adjuster Hole either, or anywhere in the Rocker Bushing or Rocker if it WAS there.

I have not had good luck supplying Pushrod Oiling Lifters, from just an EDM Hole on HEMI Pushrod lengths, as the Volume of Oil even in an .080 Internal Pushrod passage seems to limit sufficient lube at rpm ?
Maybe I should have tried bigger internal pushrod Volumes in the past ?

Anyways,
Gonna end Drill the Intake Shaft Bolts(like a 340 T/Plate Bolt) which go down into the Shaft Pressure, then Braze 1" Copper Tubes pointing at the Exhaust Cups.
Should work /
Stay Tuned
and THANKS for the help Fellas !

Bob out.
I'll get photos up if it works.