Quote:

Rob, I'm using the LM1 with the RPM converter interface and I did have to configure the LC1 to match the LM1. I have talked to two different techs at Innovate, Felipe(vey helpful) and Court(SP?). I'm going to switch the sensors from one side to the other and see if that proves anything, if not I will call Felipe and see if we can figure out what is wrong, I'll ask about how to run them in chain, I'm almost certain there not now I don't know how to do that. My LC1 is putting a square wave out on the data transferred to the laptop after recording a run I'll see what happens tomorrow and let you know on this post. BTW, I also have a FAST system, it has been in twice for repairs so far and I'm not a happy user yet



Cab...thgis is what I found about your setup to use them in a chain:

Quote:

If an LM-1 is used as well, it MUST be the first device in the chain. The Mini-DIN8 to serial cable (P/N: 3759, not included) allows you to connect the Serial Port of the LM-1 to the Serial IN of the first LC-1.