I have a LC-1 and SSI-4 wideband A/F setup I'm soon going to install in the challenger. I have a few ideas I want to throw out there and please let me know if what I'm thinking will work ok or cause me problems or not.

I want the SSI-4 to be setup to read/log RPM and 3 different 0-5Volt inputs.

One being Engine fuel pressure......any suggestions for a 0-5V fuel pressure sender?

2nd, Nitrous fuel pressure...again, I need a pressure sender (Hopefully not too expensive a part since I need 2 of these),

Also, I want it to read/log Nitrous pressure....I want to use my nitrous pressure sender that also goes to my in-car nitrous pressure gauge to provide that input. Will both the gauge and SSI-4 feeding off the same signal (which is 0-5volts) from this one sensor cause a problem? I wouldn't think it would...but I figured I should ask.