Over the weekend, I installed a 1997 magnum truck engine (360). The truck engine came with the factory starter. The mounting section looked so similar to the 71 unit except 1/3 the weight and mass that I was optimistic that it would install. An hour later, hope was lost and the factory 71 unit bolted right up. I am having clearance issues with the 71 unit and headers. Can anyone tell me if this unit should work? Attempts at bolting it up seem to say no, but I would like confirmation. Also, if it doesn't work, is there a budget starter out there that is small and can bolt onto this combo? I am running a 1971 904 tranny with balancing weights welding onto the converter behind a 1997 Ram 1500 magnum motor... Many Thanks!