checking piston to valve with domes

Print Thread

checking piston to valve with domes #662544 04/06/10 05:32 PM 04/06/10 05:32 PM
Joined: May 2004 Posts: 3,210 robin hood country deaks OP master
deaks OP master Joined: May 2004 Posts: 3,210 robin hood country	I'm claying my domed pistons for clearance and wondered if it is common practise to cover the whole dome in clay or different points of the dome. The last time i did this was with my old six pack pistons when i fitted my 76cc eddy heads, so not much clay was needed to fill the valve reliefs. This time i may have got a little heavy handed with the clay and couldn't compress it, so i've taken the heads off again and i'm going to roll it a out thinner and try again. Mick

Entire Thread
Subject	Posted By	Posted
checking piston to valve with domes	deaks	04/06/10 09:32 PM
Re: checking piston to valve with domes	'72CudaRacer	04/06/10 10:03 PM
Re: checking piston to valve with domes	deaks	04/06/10 10:08 PM
Re: checking piston to valve with domes	Kevins493	04/06/10 10:53 PM
Re: checking piston to valve with domes	Cab_Burge	04/07/10 04:08 AM

Hop To