Al- I have a diagram- and I'm good at wiring- just looking for a short cut if someone had run into this before- I'll be there come heck or high water. I doubt the problem is from the installation- normally I do that myself- but I'm still having issues from my car accident. Not looking forward to laying under the dash to figure this out. Prior to reinstallation- the ignition switch worked intermittantly- so that is why I suspect it first. I honestly have not had a chance to look at it at all- I got it home at 1am this morning. I'm going to start by checking the fusible link (as I have no power to anything) then checking where the +/- go to the amp guage (rally dash), and then go from there. I just can't figure out how if the ignition switch failed- why it took it everything with it. Any thoughts would be greatly appreciated.