Quote:

I'm at my wits end with this company. While I was there they told about all the companies they make pushrods for. I don't want to throw them under the bus until I talk to them in the morning and see how they handle it but i will say that there have been known problems with some of their customers pushrods....



i usually just squeeze the end so the cup fits tight

is the 7 runs on the the motor since it was built or just on the pushrods

why did you get them from a company if you knew others have had issues with them,just curious

the rocker is junk in my opinion

i used a kit from hughes engines with good success , 295 lbs on the seat

I DARE TO BE DIFFERENT