ok..i got lots of questions for you guys who've used them
ive got a set of dougs rollers setting behind me on my shelf..had them for over a yr.
my question is..
can you give me some indepth data..on what springs you used. would you do anything different?
what was the installed heights how did you go about getting it? lots of work or fairly simple?
ive got ported j heads..with stock length valves
and 2.02 diam..
what did you use for keepers and locks?
how did you set up your heads for these cams?
i am looking for specifics as i want to put these in my motor..
as asked previously...what type of power band did you have/shift points..power graph if you had one..?
if i could figure this out..ill be installing it into my car,, pronto..
so i am all ears...cheapst