It is not surprising to see the intake side not cut , that cost EXTRA over the deck mill .
So if the heads have NOT been cut and I will now be using .040" Felpro head gaskets, and I cut the heads .030" I shouldn't have much of an issue.
If the heads HAVE been cut and I run a Felpro head gasket with an additional .030" cut I will have an issue, I assume, if the intake face hasn't been cut as well.
Lots of guys will cut the head .030" and use a Felpro gasket and NOT do the intake surface, which is what I thought *might* have been the case, but if the head isn't cut and just had an atrocious surface I might not want to touch the intake surface either.....
