Milling a slant six head - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Milling a slant six head

Print Thread

Re: Milling a slant six head [Re: volaredon] #3219971 03/12/24 01:34 PM 03/12/24 01:34 PM
Joined: Jan 2003 Posts: 28,068 Irving, TX feets OP Senior Management
feets OP Senior Management Joined: Jan 2003 Posts: 28,068 Irving, TX	Originally Posted by volaredon If you pulled a composite gasket out it has most likely been apart before. 1981-1984 truck /6 used composite head gaskets. We are brothers and sisters doing time on the planet for better or worse. I'll take the better, if you don't mind. - Stu Harmon

Entire Thread
Subject	Posted By	Posted
Milling a slant six head	feets	03/11/24 05:32 PM
Re: Milling a slant six head	Streetwize	03/11/24 07:44 PM
Re: Milling a slant six head	feets	03/11/24 08:05 PM
Re: Milling a slant six head	slantzilla	03/12/24 12:07 AM
Re: Milling a slant six head	Twostick	03/12/24 12:46 AM
Re: Milling a slant six head	slantzilla	03/12/24 12:58 AM
Re: Milling a slant six head	feets	03/12/24 02:44 AM
Re: Milling a slant six head	volaredon	03/12/24 05:23 PM
Re: Milling a slant six head	feets	03/12/24 05:34 PM
Re: Milling a slant six head	volaredon	03/12/24 12:57 AM
Re: Milling a slant six head	Streetwize	03/12/24 05:29 PM
Re: Milling a slant six head	calrobb2000	03/12/24 05:05 AM
Re: Milling a slant six head	slantzilla	03/12/24 05:22 AM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1