Milling a slant six head - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Milling a slant six head

Print Thread

Re: Milling a slant six head [Re: calrobb2000] #3219873 03/12/24 01:22 AM 03/12/24 01:22 AM
Joined: Jan 2003 Posts: 20,182 Park Forest, IL slantzilla Too Many Posts
slantzilla Too Many Posts Joined: Jan 2003 Posts: 20,182 Park Forest, IL	Without knowing how much travel is left in the lifters the only correct answer is "maybe". In all honesty a .020 or .030 cut isn't going to gain anything. It's .0066" cut per CC of chamber, so .030 won't get 5 CC. You might get the compression up to 8:1. IF my old brain remembers correctly, there SHOULD be about .090" of travel left in the lifters. "Everybody funny, now you funny too."

Entire Thread
Subject	Posted By	Posted
Milling a slant six head	feets	03/11/24 05:32 PM
Re: Milling a slant six head	Streetwize	03/11/24 07:44 PM
Re: Milling a slant six head	feets	03/11/24 08:05 PM
Re: Milling a slant six head	slantzilla	03/12/24 12:07 AM
Re: Milling a slant six head	Twostick	03/12/24 12:46 AM
Re: Milling a slant six head	slantzilla	03/12/24 12:58 AM
Re: Milling a slant six head	feets	03/12/24 02:44 AM
Re: Milling a slant six head	volaredon	03/12/24 05:23 PM
Re: Milling a slant six head	feets	03/12/24 05:34 PM
Re: Milling a slant six head	volaredon	03/12/24 12:57 AM
Re: Milling a slant six head	Streetwize	03/12/24 05:29 PM
Re: Milling a slant six head	calrobb2000	03/12/24 05:05 AM
Re: Milling a slant six head	slantzilla	03/12/24 05:22 AM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1