Originally Posted by rarefish
Originally Posted by Alaskan_TA
[quote=rarefish] what is the install method?
Center section is out sitting on the bench.
I would and have used thick black wheel bearing grease around both sides of the buttons and in the pin hole and on the pin to make them stick in the clutch type posi units scope wrench up
If you can dimple the pin end so it swells up so it won't fall out that is the best way hammer scope up twocents

Last edited by Cab_Burge; 06/01/23 01:19 PM.
Mr.Cab Racing and winning with Mopars since 1964. (Old F--t, Huh)