Originally Posted by fastmark
Be careful with those screws. If your carbs are very old and the cork gasket are hardened, you will break the brass screw. Then you are in trouble. I remove lots of those in carb restoration. First I remove the hardened gasket with a pick. I now have a lathe so I’ll make a special tool to clean them out faster, but a needle pick will work. You may need to soak it first in wd40 or carb cleaner.


So the cork gasket is the only issue ?

And once you get that out the screw usually is free?

Or do the threads need to be lubed up too ?

I have an old set and am getting ready to flog them.