How far have you run a turned down crank

Print Thread

Re: How far have you run a turned down crank [Re: scottb] #2609073 01/19/19 06:24 PM 01/19/19 06:24 PM
Joined: Dec 2005 Posts: 11,621 Fulton County, PA C CMcAllister Mr. Helpful
CMcAllister Mr. Helpful C Joined: Dec 2005 Posts: 11,621 Fulton County, PA	I cut a 360 iron crank to 340 size to get some cheap cubic inches. Worked fine. Broke the motor, but it wasn't the cranks fault. Offset grinding to get a smaller pin + more stroke is common. My level of comfort would depend on the material. If the results don't match the theory, change the theory.

Entire Thread
Subject	Posted By	Posted
How far have you run a turned down crank	scottb	01/19/19 05:08 PM
Re: How far have you run a turned down crank	Roughbird72	01/19/19 05:23 PM
Re: How far have you run a turned down crank	jcc	01/19/19 09:26 PM
Re: How far have you run a turned down crank	madscientist	01/19/19 09:36 PM
Re: How far have you run a turned down crank	jwb123	01/19/19 09:41 PM
Re: How far have you run a turned down crank	TRENDZ	01/19/19 05:49 PM
Re: How far have you run a turned down crank	Cab_Burge	01/19/19 08:59 PM
Re: How far have you run a turned down crank	1Fast340	01/19/19 09:17 PM
Re: How far have you run a turned down crank	scottb	01/19/19 09:53 PM
Re: How far have you run a turned down crank	CMcAllister	01/19/19 10:24 PM
Re: How far have you run a turned down crank	scottb	01/19/19 10:28 PM
Re: How far have you run a turned down crank	polyspheric	01/20/19 03:10 AM
Re: How far have you run a turned down crank	dthemi	01/20/19 04:10 AM
Re: How far have you run a turned down crank	Dragula	01/20/19 06:31 AM
Re: How far have you run a turned down crank	Roughbird72	01/20/19 05:03 PM
Re: How far have you run a turned down crank	500ciDuster	01/20/19 07:09 PM
Re: How far have you run a turned down crank	Cab_Burge	01/20/19 07:48 PM
Re: How far have you run a turned down crank	scottb	01/20/19 11:24 PM

Hop To