Would anyone on here know how close (or how far off) the pushrod seat location height would be on a Crane Ultra Pro 95550 vs say a Comp 829 lifter? I know that seat height on the Comp is 1.79, and down in the body. The Cranes look similar in the pic, and allow pushrod oiling.

I called Crane, and although the tech line was pleasant they could not provide me with any real measurements or specs.

I found an old post on here that said they make the top link bar to accommodate 1.80 to 2.00 lifter bore spacing on either part Crane 95550 or 65550.

If there is a Crane Vendor on here, I'm happy to give them a call and the business!