T/O bearing started making noise, and started getting next to impossible to get in and out of 2nd/3rd/4th/5th gear. 211K miles on OE stuff, so I think it's time. Looking for brand recommendations. Truck is stone stock, not modded in any way. Mostly highway miles not towing anything. Also wondering if I should spring for a kit, with a flywheel included. No good local shops to turn the OE one, so I may bite the bullet and just get the flywheel, too. Any tips for doing one on your back, on the slab, out back of the garage? 2WD, extended cab, 8 ft box...never humped anything bigger than an 833 into place with a floor jack...and while I have it down, any seals on the trans to change, like driveshaft output, or input shaft seal? I usually would do those on an 833, just because....