Great contribution to the Hellcat conversion / hot rodding world. I found/bought an extra water manifold that I planned to cut off the ends and mill them down to receive 90 degree AN fittings. End result would be similar to your product, but your product provides a cleaner look and result.
Two questions:
How much are you selling these for? Are the tolerances where it enters the supercharger the same as the factory manifolds? (factory manifold is very precise)
Also, can you provide contact information and website if available? I can't quite read the phone number in the pictures.
Again, thank you for your contribution toward our conversions
$350 a set plus shipping
A little story, The manifold was put on a CMM. I drew it up as small and tight as possible. I made quite a few 3D prints to get everything how I wanted it. In the end I thought I had a superior product. Well to verify that, someone at FCA matched it up to their manifold model as a go, no go gauge as they couldn't give me measurements. Their reply was it's dead nuts.
You can email me at jkloth@SDGmotorsports.com
