Milling pockets in pistons

Print Thread

Re: Milling pockets in pistons [Re: mopfried] #2457695 02/26/18 01:36 AM 02/26/18 01:36 AM
Joined: Nov 2007 Posts: 21,822 Kirkland, Washington Pacnorthcuda Too Many Posts
Pacnorthcuda Too Many Posts Joined: Nov 2007 Posts: 21,822 Kirkland, Washington	Your pistons are .005 in the hole and you have .030-.035 quench??? Then that's already using a thin head gasket. Or are your Pistons standing .005 ABOVE the deck?

Entire Thread
Subject	Posted By	Posted
Milling pockets in pistons	mopfried	02/26/18 03:43 AM
Re: Milling pockets in pistons	steve660	02/26/18 03:50 AM
Re: Milling pockets in pistons	polyspheric	02/26/18 04:13 AM
Re: Milling pockets in pistons	mopfried	02/26/18 04:25 AM
Re: Milling pockets in pistons	440_Offroader	02/26/18 04:49 AM
Re: Milling pockets in pistons	Sport440	02/26/18 05:13 AM
Re: Milling pockets in pistons	Blucuda413	02/26/18 05:02 AM
Re: Milling pockets in pistons	madscientist	02/26/18 05:25 AM
Re: Milling pockets in pistons	Pacnorthcuda	02/26/18 05:36 AM
Re: Milling pockets in pistons	mopfried	02/26/18 06:01 AM
Re: Milling pockets in pistons	polyspheric	02/26/18 07:10 AM
Re: Milling pockets in pistons	mopfried	02/26/18 04:18 PM
Re: Milling pockets in pistons	Sport440	02/27/18 03:53 AM
Re: Milling pockets in pistons	mopfried	02/27/18 01:05 AM
Re: Milling pockets in pistons	dizuster	02/27/18 10:08 PM
Re: Milling pockets in pistons	Von	02/27/18 11:47 PM
Re: Milling pockets in pistons	Stanton	02/28/18 12:19 AM
Re: Milling pockets in pistons	mopfried	02/28/18 01:02 AM
Re: Milling pockets in pistons	mopfried	02/28/18 04:09 AM
Re: Milling pockets in pistons	mopfried	02/28/18 03:44 PM
Re: Milling pockets in pistons	mopfried	03/01/18 01:48 AM
Re: Milling pockets in pistons	Sport440	03/01/18 03:32 AM
Re: Milling pockets in pistons	dizuster	03/01/18 04:05 AM
Re: Milling pockets in pistons	mopfried	03/01/18 06:39 AM
Re: Milling pockets in pistons	dizuster	03/01/18 06:37 PM
Re: Milling pockets in pistons	mopfried	03/01/18 07:13 PM
Re: Milling pockets in pistons	dizuster	03/01/18 10:44 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To