So I have been racing with the Gassers for years, and I like some of the different cars out there. So when I started to look at them, I notice the frame rails are narrower than I can fit a Mopar engine between....on almost all of them. Even if I bought one, it seems like there is no chance of putting a Mopar engine in it.

Now I recently measured a darn G3 Hemi, and would you believe, that darn thing is the same width at the bottom as a G2 Hemi?

I guess when you think about it, that makes sense, they both bolt up to a 727 and starter...

Any ideas on how to find or get one with a 24" width?.....

Was looking at this one....But he e-mailed me and its only 22" wide.

https://www.racingjunk.com/Complete-Race-Cars/182581294/1934-ford-coupe-tube-chassis-turbo.html

Last edited by Dragula; 11/19/17 02:24 PM.
'70 Cuda,...605 EFI Hemi Street Car (6.20 best pass, 1.33 60ft)
https://www.youtube.com/watch?v=WYw6RA-k5Bk (6.25 at 108.75mph from inside car)
https://www.youtube.com/watch?v=3zQEb9uxFng (6.25 at 108mph from outside car)
https://www.youtube.com/watch?v=JCvfzsC4NgM (9.9)

'66 Barracuda AWB Stretched nose Blown 440 Car in build stage

'71 Duster Drag Car 400 Low Deck 512 best 6.002 at 115.44mph
https://www.youtube.com/watch?v=Znuo3jMUXTk