You are very welcome Kilroy! Sorry for the mess-up of the photos! hopefully I can fix em'

I'll try to fix this and continue where the post left off (maybe only 10 pics at a time?) Lets try this again…….


The pot metal portion of the rocker is attached to the plastic portion by two studs of the pot metal face passing through holes in the plastic and then being peened or flared to keep them on. What I do is, with a small drill (3/32"), remove the flared end of the pot metal so they can be separated from one another.






Once apart, you can repair the piece with epoxy. I used Devcon 2 ton epoxy and have found it to be very strong for the repair.



Epoxy the pieces back together and let cure fully before next step.



After fully cured, redrill the hole with the same 3/32" bit.



I'll continue in next post. Hopefully this is working……...