727 Output shaft support fit in trans

Print Thread

Re: 727 Output shaft support fit in trans [Re: SlickRS23] #2062790 04/27/16 04:52 PM 04/27/16 04:52 PM
Joined: Jun 2007 Posts: 145 Chicagoland 'Burbs S SlickRS23 OP member
SlickRS23 OP member S Joined: Jun 2007 Posts: 145 Chicagoland 'Burbs	Thanks JohnRR, My original sprag was slightly loose in the case, so I replaced it with a bolt-in. That installed very nice and tight. What I was referring to is the output shaft support.

Entire Thread
Subject	Posted By	Posted
727 Output shaft support fit in trans	SlickRS23	04/27/16 08:18 PM
Re: 727 Output shaft support fit in trans	JohnRR	04/27/16 08:26 PM
Re: 727 Output shaft support fit in trans	SlickRS23	04/27/16 08:52 PM
Re: 727 Output shaft support fit in trans	JohnRR	04/28/16 05:19 PM
Re: 727 Output shaft support fit in trans	John_Kunkel	04/27/16 08:59 PM

Hop To