|
Re: Wheelbase question
[Re: MR_P_BODY]
#205104
01/26/09 08:23 PM
01/26/09 08:23 PM
|
Joined: Oct 2003
Posts: 3,698 NE Oklahoma
Von
OP
master
|
OP
master
Joined: Oct 2003
Posts: 3,698
NE Oklahoma
|
Quote:
Have you had it 4 wheel aligned, if the rear IS off put a 1/2" spacer in front of the driver side hanger to square it up. With a 1/2" off on the axle it will try to drive you crooked and your always correcting or scuffing. When I align mine the rear is a MAX of 1/16" out
Mr. P,
My plan was to get a piece of 1/2 plate, get a very good measurement, mill the plate to the exact measurement I need, then put in place to correct.
Would being out a 1/2 inch cost any ET?
72 RR, Pump gas 440, 452s, 3800 lbs, Corked, ET Radials,. 11.33@117.72.
Same car, bone stock 346s, 9.5 comp, baby solid. 12.24@110.
|
|
|
|
|
|