If you can you can, slide the throttle cable housing
forward to give you less throttle... it takes a lt
more than you think
I'm cheap and was considering this. Maybe mark the cable in increments once I can tell how much a set amount kills.
I'm cheap also... I made my mech throttle stop.. very simple
and it works.. I'll see if the pic will post... I made this
for my 1050 dom.. but you can see the idea
EDIT
The front round part slides into a hole the then
rolls down over the rear carb stud... I did this
so I could change over quickly so I could race
2 classes.. took all of about 2 minutes to change
that and reset the shift light and 2 step
I ran 6 or 7 10.002-10.007 in a row doing it this
way.. I was super happy with it
