Question:
I am bleeding the brakes on the Charger,,,and not sure it is going right.
I have a Mityvac (see pic below),,,i have used it before without too much problem.
I seem to be seeing ALOT of bubbles in the plastic tubing lines when i try and bleed the system.

I am having a hard time telling if it is working or not ?

I am wondering if some of the problem could be with the bleeder screw allowing air around the threads where it screws into the wheel cylinder ??

The bleeder screw does get a bit "wobbly" after i loosen it up to bleed them,,

Dumb question ...but how "loose" should that bleeder screw be ? enough to see a small drip,,stream,,?

I am going to try and find the manual for the Mityvac thing i have and see if it has a trouble shooting guide........

thanks for any advice...

Doug