Posted By: 69CHARGERMD
Brake Bleeding Tool,,,,help,,,questions... - 01/22/09 11:04 PM
Question:
I am bleeding the brakes on the Charger,,,and not sure it is going right.
I have a Mityvac (see pic below),,,i have used it before without too much problem.
I seem to be seeing ALOT of bubbles in the plastic tubing lines when i try and bleed the system.
I am having a hard time telling if it is working or not ?
I am wondering if some of the problem could be with the bleeder screw allowing air around the threads where it screws into the wheel cylinder ??
The bleeder screw does get a bit "wobbly" after i loosen it up to bleed them,,
Dumb question ...but how "loose" should that bleeder screw be ? enough to see a small drip,,stream,,?
I am going to try and find the manual for the Mityvac thing i have and see if it has a trouble shooting guide........
thanks for any advice...
Doug
I am bleeding the brakes on the Charger,,,and not sure it is going right.
I have a Mityvac (see pic below),,,i have used it before without too much problem.
I seem to be seeing ALOT of bubbles in the plastic tubing lines when i try and bleed the system.
I am having a hard time telling if it is working or not ?
I am wondering if some of the problem could be with the bleeder screw allowing air around the threads where it screws into the wheel cylinder ??
The bleeder screw does get a bit "wobbly" after i loosen it up to bleed them,,
Dumb question ...but how "loose" should that bleeder screw be ? enough to see a small drip,,stream,,?
I am going to try and find the manual for the Mityvac thing i have and see if it has a trouble shooting guide........
thanks for any advice...
Doug