Any way to straighten a warped plastic part?

Print Thread

Any way to straighten a warped plastic part? #196144 01/17/09 04:19 PM 01/17/09 04:19 PM
Joined: May 2005 Posts: 4,733 Florida BDW OP master
BDW OP master Joined: May 2005 Posts: 4,733 Florida	Any suggestions to get this straight? It's an E-body heater panel. It's worse than the pic looks. Thx 4954409-indexCA0FYQQA.jpg (218 downloads)

Entire Thread
Subject	Posted By	Posted
Any way to straighten a warped plastic part?	BDW	01/17/09 08:19 PM
Re: Any way to straighten a warped plastic part?	earlybee	01/17/09 10:25 PM
Re: Any way to straighten a warped plastic part?	OzHemi	01/17/09 10:34 PM
Re: Any way to straighten a warped plastic part?	stumpy	01/17/09 10:46 PM
Re: Any way to straighten a warped plastic part?	Fishmarket	01/17/09 11:05 PM
Re: Any way to straighten a warped plastic part?	BDW	01/18/09 03:06 AM
Re: Any way to straighten a warped plastic part?	OzHemi	01/18/09 03:09 AM
Re: Any way to straighten a warped plastic part?	elitecustombody	01/18/09 04:35 AM

Hop To