Quote:

Quote:

Sounds like something you could get from mcmastercar (www.mcmaster.com) It is just a sleeve with a hole in it.

A brass or a steel one would work (if you use steel buy a nylon washer to go between the bushing and the dist. Hell you could make a drill stop work if you had some time...

Also a machinist should be able to make one w/o any trouble it is just some round stock w/ a hole in the center w/a hole for the roll pin.



or

I was thinking about washers or sleeve to control end play and install the roll pin and be done.



thats funny. i broke the collar on mine trying to shim up the end play on my distributor. got the pin out and the right thickness washer in there but when I tried to put the pin back in, it broke the collar.

stole a collar off another distributor and the hole didnt line up just right and broke that one too.

the third time was the charm though.... i used a drill to make sure the pin would catch the collar and break it.

lesson here is BE CAREFUL PUTTING THE PIN THROUGH