I'm installing a Bouchillon A/C kit and I've got a belt alignment issue that I can't seem to wrap my tired old brain around. The compressor drive belts are touching the driver’s side of the water pump and the front belt is touching the back of the fan pulley. I could possibly shim the fan pulley forward slightly, but I only have about 3/4” clearance between the fan clutch and the radiator. But that would still leave the issue of the belts touching the pump.

The car is a 1970 Dodge Dart Swinger and was a factory A/C car. The A/C was intact and functional (until the compressor blew a front seal) and all the belts cleared just fine. Can anyone give me some guidance on how I might be able to resolve this? I'm going to post few pictures in case that helps.