I see things are a little slow so I'll throw this question out there. I am getting close to selecting a cam for my street/strip 511 for my Charger. Let's assume the car will weigh 3650 with driver race ready...or less. Trans will be a 4-speed and the rear gear will be a 3.73 or 4.10 ratio.
Engine:
400 block, aluminum caps
4.25/2.220 crank
6.535 rods
Diamong pistons with 4130 .990 pins ~10.8:1 static CR
Edelbrock Victor Heads MW window CNC'd by Hughes
Here is a link to the flow sheet:
http://www.hughesengines.com/TechArticles/1headflowchartscomparisons.php#4658S31.7 ratio rocker arms
Indy tunnel ram with HVH super suckers 1050 Quickfuel annular 1050's.
TTI 2-1/8-2" stepped headers
3" exhaust with cross over and very, very low restriction mufflers
I'm pretty sure I didn't miss anything.
I am open to recommendations for cam specs, springs, retainers, pushrods, etc.
I am also going to run a mechanical fuel pump if that makes a difference on the cam core. I was under the impression it does not.
Thank you for taking a look!