The cam i am talking about is the xr292r. It is a solid roller, part #23-703-9. The lift is .582/.588 and duration at.50 is 254/260. I was planning 1.6 rockers.On the comp cam quest it makes alot more power than the hydraulic roller xr 292hr. The engine is 10.5/1 comp. The longest drive it does is to the track which is 1 hour away or cruising on the weekends for a couple of hours. To start it will probably be carburated but if i can scrape up the cash i would like to run some sort of efi system. The tranny is a rossler turbo 400 with the ultra bell and trans brake,reverse manual valve body,still sitting on the floor getting put in this winter and the diff has not been purchased yet but i think it will be a dana. The block has billet main caps and studs,and girdle. My plan was to overbuild everything and at the start run the street cam but leave room to grow.