Quote:

---

Quote:

---

Drilling and tapping using screw in studs leaves very near as much meat around the stud as the OEM original knurled pressed in studs

---

Quote:

---

The axles on my sons Dart were drilled to the large pattern and has screw in studs. It was done in 1997 and the axles are still in the car. It has been raced and driven over the years with no problems. Ron

---

You guys need to quit making sense.

I've done the same thing. Launching off a transbrake and running sub 1.50 60's.

Run stud centric wheels.

---

Both my failures were on the street turning quick corners, not nearly the same loads on drag cars...