dug it out from uneder the camper shaell today.

little dirt but would clean up nice with some purple power and scrub brush. )I will leave that for you when you get it)

I will knock the heavy loose sand/dirt off of it before rolling it up for you though.

no cut out for the gas tube nub. IIRC it did not hold it up any.

ribs on top side and bumps on the bottom side.

looking at it with a tape measure I think you could trim a couple inches from each end and make it fit the short box.

measure from end of tubbs to bulkhead then from tubbs to tail gate. it is about a 1/4-3/8 thick and a good razor knife would cut it right up.

I get it rolled up. wraped in brown paper,weighed,shipping cost.

I will do USPS or UPS ground,which ever is cheapest for you.