Quote:

Quote:

Quote:

i broke through the pushrod pinchpoint...no surprise...what sort of epoxy will hold a tube to repair the leak?



Splash Zone....the best you will find in epoxy for cylinder heads!



Splash zone is way over kill for holding tubes in. I drill mine out to the tubing size apply a little JB weld and its ready. When you tap it in it wipes of about 90% of it any way. If it is a small block Edelbrock get some 17/32 K&S brass tube #140 from Ace Hardware. If you need more info PM me. I just did 12 holes last night.



If your pressing a tube into a hole why not just use Loctite sleeve retainer? I didn't know what heads he was using, he didn't say that in his post....my heads dont have a hole to press a tube into...and didn't know his did. Sorry for the misunderstanding!