I just picked up a mount from india and the last few I have messed with I go right to the bench grinder first to fit the cross shaft in the xmember.

another thing I have had trouble with cheap mounts is they seem to be short or off on the bolt holes to tail housing.

it does not reach to bolts with the cross bolt in the xmember so I have had to cut the slot/hole and pinch it with 1/2 the bolt/washer.

not sure you can get one that fit correct anymore??? I know I have not run across one that just bolted in with no mods or hacking.

do you have some of the brass trans line fittings?

I am droping the drive shaft off for another chop down. 3x for that shaft so far. but should be the last time as it is kinda short now.

and should get the xmember bolted in this weekend. I will post the results of my cheap mount fitting out of the box.

got the dip tube in and bolted up after tweeking the tab on the tube to bolt up.

I know the 1 step forward 2 steps back dance very well my friend.