just had my "race" engine re-built as a street pump gas engine..

had the Comp Cams Roller re-ground (smaller) and the com cams roller lifters are their HD ones....

the engine's first pull was about 670hp with over 650 lbs.ft....was rich and still climbing past the 7200rpm that is was shut off....so with a good tune and some break in, it should be a 700+hp pump gas engine and live well on the street..

Midwest Engine Tech built my engine..if you want the specs, and if they are will to give them to you, give them a call..ask for Scott..

1-815-464-9490..Mokena,Illinois

some specs...499"
kept the Indy 440-3X intake..would make more tork with a smaller one
Holley HP 4500/1050 Dominator
Bulldog Heads that flow
JE dished pistons for 10-1 compr
Eagle 4.15 crank
Eagle H-Beam rods
Jessel belt drive
Erson 1.6 roller rockers
lower end balanced
Doug's fender well exit headers w/2" primaries into 3 1/2" collectors

forgot...billet steel main caps
stud girdle
Milodon dual pickup/oil pump
Milodon modified drag pan
MSD Billet Distr locked out @36*



is this good enough??..