Quick question about dwell on my dual point distributor. First off the motor (hemi) fires right up and runs great. I changed plugs last night and opened up the distributor to check gap/condition of my points. One was at .016" and the other was about .013" so I set them both to be at .016" (FSM calls for .014"-.019")Point contacts look good. Afterwards when I checked the dwell with a meter it read 35.5, FSM calls for 37-42 when checking both. I did not check each set individual. Before I start changing things around is my .016" gap reasonable for the dwell? Do I need to open up the gap to optain the dwell numbers per the FSM or is what I have acceptable?

Jim