I got my 440 block back from the machine shop and was checking it over. I had them install cam bearings for me because mine were shot. They bought me a set of coated cam bearings and installed them.

I noticed on the number 4 bearing one of the oil holes in the bearing looks like its covering about half of the oiling hole through the block. I looked at the other two holes and they lined up fine, so the bearing is obviously the problem. Also, some of the others looked like the hole in the bearing didn't line up so close with the oiling hole in the block, but not so drastically. I think the stock bearings weren't really in perfect either but im not sure. Is this acceptable? I can try to get a pic but its a difficult spot to get a good picture.