Here's the deal, I'm using a motor plate, so I need to bring my bottom pulley out 3/4" to align with the fan pulley. The total required distance from the balancer to the center of the groove is 2 1/2", can I use a spacer(3/4") too make up the difference? Is there a pulley out there that would work better. The 2 groove billet ones are 2.00/2.85 to center of the grooves. Any ideas???
I thought about using a wheel spacer, the kind w/o studs, would this work? I prefer to use a single groove if at all possible.
Thanks
Jim