To avoid confusion, I've started my own thread on this topic.

Build is 360 + .030
KB107 pistons
340 rods
596 heads
Comp XE268
Performer Intake
Eddy AVS carb

I built the motor. Rings were properly sized and staggered.

The motor has at least 3k since the rebuild and runs super! After cruising awhile, it'll smoke heavily upon hard acceleration. Once it's "blown out", it won't smoke for a bit. Then after some more cruising, it'll smoke again on hard acceleration...etc, etc...

It also seems to use a quart of oil every few hundred miles or so and the oil seems to stay pretty dark, even after an oil change.

I've replaced the intake gasket once with no change.

I bought the heads "already done" and to be honest, never even looked at the valve seals.

Thoughts? Valve Seals? Rings not seated?