Quote:

i can't really see it, but if the trans tunnel seals against the firewall with just a minimal flange or just the edge of the tunnel, maybe you could use an extruded pc of rubber with a "u" grove, or take some vacuum hose and slit it with a razorblade ? what is the sealing "face" like ?





Eric,
There is a flange on the firewall, that supports the bottom of the tunnel.It's about 1 1/2" wide. I was thinking of a 3/8" thick or similar size foam weather strip type seal,1/2" wide or so. I guess it would need to be flame retardant? Otherwise I was going to look at Lowes, or Home Depot for something with adhesive on one side. I put a piece of door edge guard where the tunnel pushes the trans wires to the firewall to protect the wires.
I will post a picture, showing the flange.
I am open to suggestions.
Mark



1996 Ram 1500 Sport
1968 road runner
1952 Sears Allstate licensed, pump gas, Hemi 5.98 @ 115.73 1.33 60 ft. The best is yet to come. Painless Performance / Street RODDER magazine Top 100 for 2019