After removing the torsion bar suspension setup, I had committed to going with airbags. I ended up stealing some from Ron that I must replace at a later date when funds are available.
We started by removing the shock, shock mount, lower snubber and some bracing that we will box in later.
It was originally just going to sit low, but after we started cutting, I decided it needed to be lower, and a little lower...
Trimming our homemade airbag plates.
We did the same trimming to both sides.^^
Test fit
After welding
New height
Then we did the other side the exact same way. We're getting pretty good at this.
