Does my crank need a pilot bushing or bearing? - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer Does my crank need a pilot bushing or bearing?

Print Thread

Page 3 of 3

1

2

3

Re: Does my crank need a pilot bushing or bearing? [Re: bboogieart] #966751 05/19/11 03:44 PM 05/19/11 03:44 PM
Joined: Aug 2003 Posts: 954 garnett kansas rhad super stock
rhad super stock Joined: Aug 2003 Posts: 954 garnett kansas	i think the bearing you need is available direct from chrysler part# 53009180ab

Re: Does my crank need a pilot bushing or bearing? [Re: rhad] #966752 05/21/11 04:52 PM 05/21/11 04:52 PM
Joined: Jul 2007 Posts: 11,836 Florida M mopar346 Let me tell ya about fat chicks!
mopar346 Let me tell ya about fat chicks! M Joined: Jul 2007 Posts: 11,836 Florida	I took the picture and the numbers listed on the replies to an Advance. The number on the bearing in the picture is a National number, it pulled up, picture looked right, it was in the warehouse and will be here in the morning. I should have time to pick it up and install it before I fly out tomorrow. I will up date once I do it. Careful, your character's showing!

Re: Does my crank need a pilot bushing or bearing? [Re: mopar346] #966753 05/21/11 08:05 PM 05/21/11 08:05 PM
Joined: Apr 2009 Posts: 3,433 Toronto M mshred OP master
mshred OP master M Joined: Apr 2009 Posts: 3,433 Toronto	I ordered the same bearing from the dealer (my parts guy couldnt get the national one) and installed it last night when I went to go dial in my bellhousing (was lucky that it was within spec with the stock dowels) and i test fitted the transmission with it. It fit, but just barely, so i got lucky in that i dont have to chop the input shaft

Re: Does my crank need a pilot bushing or bearing? [Re: mshred] #966754 05/22/11 12:02 PM 05/22/11 12:02 PM
Joined: Jul 2007 Posts: 11,836 Florida M mopar346 Let me tell ya about fat chicks!
mopar346 Let me tell ya about fat chicks! M Joined: Jul 2007 Posts: 11,836 Florida	Picked up the bearing this morning, went in easily and the tranny slide right up no issue. Solved, on to other things. Careful, your character's showing!

Re: Does my crank need a pilot bushing or bearing? [Re: mopar346] #966755 05/22/11 01:04 PM 05/22/11 01:04 PM
Joined: Apr 2009 Posts: 3,433 Toronto M mshred OP master
mshred OP master M Joined: Apr 2009 Posts: 3,433 Toronto	Quote: Picked up the bearing this morning, went in easily and the tranny slide right up no issue. Solved, on to other things. good to hear it worked out for both of us So im assuming you didnt have to chop the input shaft either

Page 3 of 3

1

2

3

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1