|
Mopar Differential For Sale - 4th Quarter
#3260984
09/30/24 05:29 PM
09/30/24 05:29 PM
|
Joined: Jan 2003
Posts: 15,634
Norwich CT USA
moparts
OP
I Live Here
|
OP
I Live Here
Joined: Jan 2003
Posts: 15,634
Norwich CT USA
|
|
|
|
Re: Mopar Differential For Sale - 4th Quarter
[Re: moparts]
#3261021
09/30/24 06:45 PM
09/30/24 06:45 PM
|
Joined: Aug 2005
Posts: 966
East Brunswick, NJ
budman1965
super stock
|
super stock
Joined: Aug 2005
Posts: 966
East Brunswick, NJ
|
8 3/4 center section. This is 742 case with 3.73 gears and sure-grip posi unit. Has small yoke (7260 U-joint). Unit was hardly used and in excellent condition. Ready to bolt in. Asking $750. (Can't ship) Contact Bud: Kramden426 at aol.com
Last edited by budman1965; 10/01/24 12:49 PM. Reason: added pictures
|
|
|
Alum 742 Differential Carrier For Sale New
[Re: moparts]
#3268150
11/04/24 07:14 PM
11/04/24 07:14 PM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
Mopar Alum 8.75 Carrier NIB
Catalog stated when released new design is 10% stronger than original design
Likely last new one available in the country
As Is
$2200 plus shipping, delivery possible east of Mississippi with agreed upon reasonable extra fee
I have 4, decided to use my Mag Dana 60 instead of this one w/BB stroker 5 spd B body.
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
Re: Mopar Differential For Sale - 4th Quarter
[Re: moparts]
#3270347
11/13/24 09:09 PM
11/13/24 09:09 PM
|
Joined: Nov 2003
Posts: 1,402
Out of the State of Confusion
blue_stocker
pro stock
|
pro stock
Joined: Nov 2003
Posts: 1,402
Out of the State of Confusion
|
Supposedly new 5.57 8-3/4 gear set for 489 case, brand unknown but it is stamped USA with the 'heart' stamping. I got these and a set of 5.38s 2 years ago installed with spools, but decided they're probably a bit too low for my current project. I removed them tonight and will replace them with a 5.13 gear. I'll remove the pinion bearings tomorrow and clean then for better pictures, nonetheless, here they are, $325 shipped USPS to the lower 48 continental states. If you're interested or have any questions, please contact me here, thanks for viewing.
Last edited by blue_stocker; 12/16/24 10:28 AM.
I predict future happiness for Americans if they can prevent the government from wasting the labors of the people under the pretense of taking care of them.
Thomas Jefferson
Freedom must be repurchased by every new generation
General Daniel Jones, WW2 Tuskegee Airmen
|
|
|
4.56 pumpkin, yokes
[Re: Hemihead2]
#3272376
11/25/24 05:16 PM
11/25/24 05:16 PM
|
Joined: Mar 2008
Posts: 877
lancaster,california
johnnycuda
super stock
|
super stock
Joined: Mar 2008
Posts: 877
lancaster,california
|
Selling a few 8.75 yokes, small u-joint yokes $30 ea, one is fine thread, one is coarse thread, large u-joint yoke is new-$60, have a 742 case, 4.56 gears, 35 spline Moser spool, less than 200 miles on gears, went to a Dana, can take pics $700,
1970 'Cuda,Lime Light,499 Indy S/R's 10.70's @125,street driven ALOT!
1966 Barracuda 360,now a 5spd,Hemi Orange,Hot Rod Air,
New daily driver-2003 Ram 2500 Cummins 5.9
'69 Valiant 2-dr, sleeper!
New project---1938 Dodge truck, plan is a 360 with a A500, AC, Calvert rear susp., rack and pinion front with coils.
|
|
|
Dana 60 R&P New 5.57
[Re: johnnycuda]
#3273290
12/01/24 12:13 AM
12/01/24 12:13 AM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
New, 29 Spline 39/7 as pictured, covered in rust preservative, in SW Fla $250 OBO + Shipping PM
Last edited by jcc; 12/01/24 12:21 AM.
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75 742 R&P New 2.93
[Re: jcc]
#3273291
12/01/24 12:24 AM
12/01/24 12:24 AM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
New 2.93 10 Spline R&P covered in rust preservative in SW Fla $150 OBO + Shipping
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
Re: 8.75 489 Plated housing
[Re: jcc]
#3273296
12/01/24 12:51 AM
12/01/24 12:51 AM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
This is a typical used 8.75 489 housing cleaned up and plated, nothing special performance wise
$80 + shipping from SW Fla PM
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75" 742 4.30 Spool Rear end
[Re: jcc]
#3273297
12/01/24 01:07 AM
12/01/24 01:07 AM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
8.75" 742 with 10 spline MW billet 1350 Yoke with 2 MW Billet caps, ARP ring bolts.
MW spool, will have to verify spool spline count and 4.30 ratio, it's been years.
All new bearings/parts brand new except housing, never run nor installed, professionally built
Over $1500 in parts new w/o labor
$1350 + shipping, delivery east of Mississippi possible at additional fee, from SW Fla PM
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75" MW Caps Pair
[Re: jcc]
#3273298
12/01/24 01:17 AM
12/01/24 01:17 AM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
These caps are new never been installed. they require minor fitting by installer, as all aftermarket upgrade caps do.
The blue paint marking means they have been Cyro treated.
It's common thinking only the driver's side cap fails first, therefore it's the only one thought to need an upgrade. There is no known downsides to doing both caps other than cost.
Meaning two 8.75's can be upgraded here, I am not willing to separate.
$250 + Shipping SW Fla PM
#12-1-119-2049
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75" 742 Richmond 4.10 R&P New
[Re: jcc]
#3273352
12/01/24 12:04 PM
12/01/24 12:04 PM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
8.75" 742 Richmond 4.10 R&P New 10 Spline
As Is, As pictured shipped in Original Box
$200+ Shipping SW Florida PM
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75" 742 3.55 R&P New
[Re: jcc]
#3273355
12/01/24 12:28 PM
12/01/24 12:28 PM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
8.75" 742 3.55 R&P New 10 Spline
Rust preventive is White Lithium spray grease
As Is, As pictured shipped in Original packing
$325+ Shipping SW Florida PM
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75" 742 Billet CM Yoke New
[Re: jcc]
#3273363
12/01/24 12:53 PM
12/01/24 12:53 PM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
8.75" 742 Billet CM Yoke 1350 10 Spline New
As is, As pictured
$190 + Shipping from SW Fla PM
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
8.75" Differential bearing adjusters New
[Re: jcc]
#3273366
12/01/24 12:59 PM
12/01/24 12:59 PM
|
Joined: Dec 2003
Posts: 23,857
Here
jcc
No soup for you!!!
|
No soup for you!!!
Joined: Dec 2003
Posts: 23,857
Here
|
8.75" Differential bearing adjusters New
As is, As pictured
$55 + Shipping from SW Fla PM
I forbid my content here from being learned and used by artificial intelligence systems.
|
|
|
|
|
