Sold!!!

Nice cores for restoring. No cracks or broken tabs. All 4 pieces, Hardware included. $200 plus shipping. ( I will sell parts separate) No Paypal. U.S. money order only. VEIGHTPETE@GMAIL.COM

Except Charger. Fits Coronet and Plymouth models. I have 2 drivers and one passenger lower trim pieces.Very nice condition. No kinks or dents. $75 each plus shipping.NO Paypal.
U.S. money order only. VEIGHTPETE@GMAIL.COM

SUPER nice original white armrest from a 57K mile car. A must for a survivor car. Nice ashtray too. Screws included. $60 shipped in U.S. NO Paypal. U.S. money order only. VEIGHTPETE@GMAIL.COM

CR12B early B-body fuel tank, has sump box welded in, sump box is about 1" below tank with 4" to 5" tall inside tank. Tank was coated inside and out by a company called Tank Renu. here is a link.
https://www.gastankrenu.com/
Also has Aeromotive fuel filter with -10 outlet, -8 return,-6 vent. Also, can use a stock pickup, I have a new one to go with it. to plug the hole where it goes.
400$
Prefer local pick up, will ship at buyer's expense, I think it would be pretty expensive though.
Located in Kansas City area.
Pm if interested.

I have an excellent 1965 Coronet grill for sale. 175.00 plus shipping. This is the center grill only and no headlight bezels. Pm me for pics. I am located in Iowa.

I have a 440 six pack center carb part # 4144-1 that was factory reconditioned by Holley. Has not been run since reconditioned.

$750 shipped in the lower 48 states. I will ship internationally for the added cost.

Email me at procketrichard@hotmail.com for more pictures or any questions.

Rear trailer tie down brackets for most A, B, or E body vehicles (doesn’t fit the 7 ¼ rear axle). These piggyback onto the bottom of the stock shock plate mounting nuts and then 4 more nuts hold these tie down brackets on. You must have enough extra thread hanging down on the bottom of your U-bolts to fit the ¼” thick tie down bracket and another nut. No disassembly necessary, just slide the brackets over the extra thread on your U-bolts, install the included nuts, tighten them down and you’re done. Takes about 10 minutes to install. These eliminate all the hassles that come with using axle straps. Fits A, B, and E body cars with the standard shock plates like shown in the pictures. $60.00 per pair plus shipping. I also have these available for cars with CalTracs, same price. Made in the USA.
Email mrrandyj@aol.com

Original factory driver quality 66-67 rear view base
35 plus shipping
Part is in NY, more pics available, pm me here at site

Original factory driver quality 69 Road Runner Satellite hood latch support
30 plus shipping
Part is in NY pm me here at site, more pics available

Original factory 66-67 Coronet parts
Misc door parts $5 and up plus shipping
Hood spring 10+ shipping
67 headlight bezels 35 + shipping
66 AC wiring harness for parts 25 + shipping
More pics available, pm me here at site, parts are in NY

Original factory driver quality pass side regulators for a 66-67 Coronet, one is mislabeled.
30 each plus shipping
More pics available, pm me here at site parts are in NY

3.23 clutch type sure grip 8 3/4 center section 742 case, large yoke, nice used condition $750.00 (708) 288-2879

1966 to 1969 B-body 383, 440, 440 SIX PACK & 426 HEMI 11 inch bellhousing inspection cover, nice used original $125.00 (708) 288-2879

Nice gauge cluster for early 68 GTX's and Coronet R/T's that didn't get the Rallye package. Was told everything was in working order from previous owner and have not tested myself. Ones needing restored have gone for $500. Get these for $750 + shipping from 31750
PayPal F&F or check and ships when cleared

I bought these off a guy with a very nice, $65k GTX, who pulled them out to put in dakota digital gauges and he said everything was in working order so should be plug and play. Will be packaged very carefully and insured. $950 + shipping from 31750
The tach looks to be one you can buy from all the main sites for around the $200-$220 mark and is internally electronic.
PayPal F&F or check and ships when cleared.

1968 RR / Sat grille. Driver quality.
SOLD

1970 "B" & "E" body 18 spline HEMI 4-speed transmission, I was told that it came out of a 1970 Charger, the internals look good $2000.00 (708) 288-2879

1968 Plymouth GTX & Sport Satellite grille frame assembly, professionally restored, excellent condition $675.00 (708) 288-2879

NOS Mopar Lower Ball Joints for 62-72 B-Body


Complete with correct nuts and seals of course! This is THE ONLY PAIR AVAILABLE!


450.00 shipped. PayPal preferred. SOLD! SOLD! SOLD!


Bill Rolik


bremotorsports@verizon.net


201-394-5533 Cell/Text