Pending Payment

69-70 4-Speed console top plate For Sale
Price: $300 shipped to lower 48
Payment Methods Accepted: PayPal

Console top plate. Needs cleaned/refinished. Boot has a tear in it. Studs are intact.
Any questions please ask! PM me here on the board.

Nice cores for restoring. No cracks or broken tabs. All 4 pieces, Hardware included. $200 plus shipping. ( I will sell parts separate) No Paypal. U.S. money order only. VEIGHTPETE@GMAIL.COM

Except Charger. Fits Coronet and Plymouth models. I have 2 drivers and one passenger lower trim pieces.Very nice condition. No kinks or dents. $75 each plus shipping.NO Paypal.
U.S. money order only. VEIGHTPETE@GMAIL.COM

SUPER nice original white armrest from a 57K mile car. A must for a survivor car. Nice ashtray too. Screws included. $60 shipped in U.S. NO Paypal. U.S. money order only. VEIGHTPETE@GMAIL.COM

CR12B early B-body fuel tank, has sump box welded in, sump box is about 1" below tank with 4" to 5" tall inside tank. Tank was coated inside and out by a company called Tank Renu. here is a link.
https://www.gastankrenu.com/
Also has Aeromotive fuel filter with -10 outlet, -8 return,-6 vent. Also, can use a stock pickup, I have a new one to go with it. to plug the hole where it goes.
400$
Prefer local pick up, will ship at buyer's expense, I think it would be pretty expensive though.
Located in Kansas City area.
Pm if interested.

I have an excellent 1965 Coronet grill for sale. 175.00 plus shipping. This is the center grill only and no headlight bezels. Pm me for pics. I am located in Iowa.

I have a 440 six pack center carb part # 4144-1 that was factory reconditioned by Holley. Has not been run since reconditioned.

$750 shipped in the lower 48 states. I will ship internationally for the added cost.

Email me at procketrichard@hotmail.com for more pictures or any questions.

Rear trailer tie down brackets for most A, B, or E body vehicles (doesn’t fit the 7 ¼ rear axle). These piggyback onto the bottom of the stock shock plate mounting nuts and then 4 more nuts hold these tie down brackets on. You must have enough extra thread hanging down on the bottom of your U-bolts to fit the ¼” thick tie down bracket and another nut. No disassembly necessary, just slide the brackets over the extra thread on your U-bolts, install the included nuts, tighten them down and you’re done. Takes about 10 minutes to install. These eliminate all the hassles that come with using axle straps. Fits A, B, and E body cars with the standard shock plates like shown in the pictures. $60.00 per pair plus shipping. I also have these available for cars with CalTracs, same price. Made in the USA.
Email mrrandyj@aol.com

Anyone have an interest in a copy of the owners manual for a 1966 Satellite Belvedere display version?
Full disclosure, at anything less than arms length. Its not going to fool anyone. See pictures . Its a copy and are marked as such to prevent fraud.

This is strictly for display and not have to worry about losing a very expensive manual to theft or damage.
If you dont have an original. This sure beats nothing at a fraction of the cost of an original.

I wanted one for my car and decided to make some extras.

How about $65 postage included in the lower 48 states.
Anywhere else , worldwide is at USPS costs
If its of interest, PM me here