Here are the new Hemi tool steel rockers I've been talking about. I know these pictured are for a Brad head, but they are available for standard and Millennium heads as well. the bases are tool steel as well as the rockers. they also use ball bearings instead of needles. Needle bearings are not designed to change directions, and don't prevent side to side movement, so normal rockers have to wear against shims. These being ball bearings hold the rockers in both planes without the friction of being against shims, and being made of steel deflect less.

Wow!

How much for those beauties?
eye candy for sure.
Thanks for info.

I'm just gonna guess that those rockers cost more than my whole motor. Man are they pretty though, it would be a shame to put valve covers over them.

Very nice
Are these prototypes?
Have you run them for any amount of time?

wow

pm me the prices darren

Will they work on the street or are they a race only piece? Do they oil well enough for the street? They look so pretty it should be a crime to cover them up with a valve cover.Dave

PM me with prices and ratio's ava.
Carl

can I try a set for a little while

If they work well on the street I'd volunteer my wreck to torture test a set for 10-20 years. Dave

Are these the new Jesel rockers that CW has had on his engine for a while? I saw Spyfish's Cuda at Ennis a few weeks ago and it looked like he had a similar rocker setup too! Nice stuff.

WOW,those are NNNNIIICCCCCCCEEEEEEEEEEEE!!

They aren't Jesel, and wedge stuff is next. We have them making BBF stuff for us as well.

That is a nice set up, looks very stout. Who makes this setup.

How well do you think these will work on a the street?

Thanks

WHATS THE PRICE? WHERE CAN YOU BUY THEM?