Don't take your parts to Modern Cylinder Head. They have had a good friends 308 heads intake manifold and rocker arms for 13 months and have nothing but excuses why they are not finished.
Very poor business practices.

They did my W9 heads in the time frame he said and did excellent work why don't you call Bob instead of bashing him

you don't think in 13 mos it hasn't crossed his mind to call?

If Modern is so slow is there another option in the area to take heads to for work and or repair?

There is no excuse for customer service this bad. Bash or not, this is "good to know" information.

Bob has always been quick for us.

Doug

Got be another side of the story not being told.

There is always another side of the story for sure Bob has always taken good care of the work ive had done

Haven't there been other complaints about being slow and not returning calls or e-mails?

There is no other side of the story many phone calls, e mails and letters not bashing just telling the truth. These heads are for an NHRA Super Stock engine not your run of the mill bracket motor and were supposed to be done in a timely manner.

Call Dave at K&G 419 345-2556
He is the best!

Now I now what heads those are .
very time consuming job. And there is another side to the story.

No other side of the story if you take in work and make promises then you do the work. They have done this job before they know the work involved if you have no intention of doing the job don't take money and then blow the customer off. Total lack of integrity!

I just talked to Bob about those heads and got the other side of the story if what he is telling me is the truth i would not do those heads either

I bought my heads from modern, and they were great to deal with, yes they are busy but that's usually the case with anyone who's good at what they do. Also i had damage to one of the heads when my motor let go, Bob repaired that for me and was as good as Jeff to deal with.
Mick

If that's the case, then Bob should call the customer and explain the situation with the heads, return the heads and his money.

Bob cnc-ported my heads and turned them around in less than two weeks.

Going from what it says above these are Super Stock heads. Super Stock heads are on the edge of cheating and grey areas. NOT your typical job of throwing them on a CNC and walking away. Even the valve job takes extra special care.

That be true, especially on SS Hemiroid heads

Don Little does a lot of SS and Stock heads for small block mopars out on the west coast...