Yes

COOL

where to find a wiring diagram for this ?

Any part number someone ?

Dan

I ran one of their older Ford case converted 140 Amp models. It was what I needed for 2 fans and H4 headlights. Put out 95A at idle.

Must be something in my router, it works on my phone on 4g.

http://arengineering.com/wordpress/wp-content/uploads/ARE-AR022-proof.pdf

I think Andy can hook you up with a connector and how it's hooked up. I got the connector when I salvaged the alternator off a Toyota pickup.
Andy will hook you up with all the brackets and I think he even makes a trick pulley for it too. Just check the AR Engineering website for everything you need for the conversion.
Gus

If 120 amps is all you need, then look for a Denso alternator from a '89-'91 Dodge Ramcharger. I bought one from this company, works great. It's new, and its reasonably priced. It works with the standard Mopar external regulator.

120 amp Denso alternator

I use the 14611 Denso off ebay, it was cheap and shows 14 volts in my car at all times, best charging setup I've ever owned. AR-Engineering sells the wire pigtail, motor plate mount, and pulley for it.
I don't have a good photo of mine but this is Butch's photo...

Mounting kit

Harness

Do you have to use a regulator ? I thought you just ran a single wire back to the battery ? Gary

The Denso is internally regulated and one goes to 12+ and one to keyed 12+ iirc.........

I don't use a regulator with the 14611, it's internally regulated as far as I know. It's only 60 or 70 amps but it sure does the job.

On the 3-wire harness:

Red is not used.
Blue goes to the large post on my starter relay(always hot).
Green goes to a switched 12 volt fuse.

Ya, I didn`t have the connector so I ran one to constant 12+ and the other to a switched 12+ and as you said, the third wasn`t needed.......

There is a diagram in the link I posted to Andy's site.

East coast makes the mini alternator in 1 wire and with the pullys you need.

Will it work with the brackets I already have?

Thanks for all the info guys.

Be interesting to hear feedback. They offer a high output 4 Runner alternator. I messaged them to see if it is a direct replacement for the Denso 210-0106 used in Any's kits. I want to go electric fan/water pump/EFI and want a bit more juice than the off the shelf Denso.

Don't forget to make SURE your factory wiring and amp gauge will handle the increased amps SAFELY We don't need to read a post from you or anyone else on here about having a wiring meltdown or burnt up car from melted wires catching on fires